• Ahoy and Welcome to the New SSS Forums!!

    As you can see, we have migrated our old forums to new software. All your old posts, threads, attachments, and messages should be here. If you see anything out of place or have any questions, please scroll to the very bottom of the page and click "Contact Us" and leave a note with as much detail as possible.

    You should be able to login with your old credentials. If you have any issues, try resetting your password before clicking the Contact Us link.

    Cheers
    - Bryan

Monitor Vane

E

excal157

New member
Anyone have any experience with a Monitor on a J/120 or similar boat. I have a B&G hydraulic autopilot which works great, esp with app or true wind, but I am looking for an alternative which doesn't draw as much power. Concerned about Monitor when surfing waves with big shifts in apparent wind.
Feedback would be great.
 
I have a monitor windvane on my J120, and also have the B&G hydraulic belowdecks as well. Works pretty well in most conditions, but if you've got a the J120 surfing downwind with the spinnaker up I've found it's better to use the B&G! Even then, I switch the B&G back to compass mode rather than apparent wind, because it won't drive to true wind like some of the later models. But the Monitor will drive a spinnaker just fine so long as you don't start getting crazy with the surfing. But I would expect any windvane would have similar problems, since it's the apparent wind that's the problem.

Here's a link which shows you how I set up the monitor.

http://www.selfsteer.com/boats/view.php?boatTypeID=1186

- Mark/Alchera
 
surfing with a Monitor

To use a Monitor windvane under surfing conditions, the game is to do two things:

1. have the boat on a point of sail such that the monitor, when it corrects for the apparent wind shift during the surf, does not push the bow through DDW and into a round down

2. reduce the monitor's sensitivity to wind shifts

1 is easy - you reach up a bit higher than you might under electric autopilot.
2 is also easy - place a downward force on the Monitor's air-paddle counterweight (such as a bungee cord run between the counterweight and the vane's structural tubes).

Adjust the tension on the bungee as needed to cause the Monitor air-paddle to return to upright quickly. I've used this extensively for running deep under spinnaker (and downwind twins) when I do want to track wind shifts. My boat is 45' IOR 2 ton lead mine, and does not so much surf as surge.

And I agree with Mark - surfing under spinnaker is not the Monitor's strong point.

- rob/beetle
 
You must log in or register to reply here.
Back
Top